How To Reset Carbon Monoxide Alarm After Replacing Batteries. Look on the front panel to find the reset button. 4 place the co alarm into the cradle.
Press the reset button and replace the 9 volt battery or 2 aa batteries (depending on the brand of carbon monoxide detector you have such as a kidde or first alert brand) to stop the beeping.push and hold the silence button for 5 seconds to silence the alarm while contamination is being burned off the sensor.reconnect the power and reinstall the. Some models may also flash a light. 4 place the co alarm into the cradle.
Some Models May Also Flash A Light.
Your device should start functioning properly again after that. Look on the front panel to find the reset button. 5 press and hold the reset button until.
Thus, You Should Keep Your Manual For Safe Keeping.
This should completely reset the smoke alarm and discharge any remaining battery. Use a microfiber cloth or compressed air to clean the device. For those alarms that automatically reset on their own, it usually resets within 10 minutes after any of these situations.
Reinstall The Battery Backup And Listen For A Chirp To Confirm That The Device Is Back In Operation.
The detector has sensed rising levels of carbon monoxide; For these smoke alarms, first, remove the battery from the device and hold the test button down for a minimum of 15 seconds. A carbon monoxide alarm’s reset button will normally be in the same place on all models;
How To Reset Carbon Monoxide Alarm After Replacing Batteries.
Some carbon monoxide alarms also will flash a light in addition to the beep when it is reset. Release the reset button, and listen for a beep. However, it’s always recommended to call a professional to check the unit for any damage.
Let Go Of The Reset Button And Listen For A Beep From The Model.
Remove the carbon monoxide detector from the mounting plate by rotating it counterclockwise carefully. 2 remove the batteries from the co alarm. It’s on the front panel, though the exact location and size of the button vary by brand and model.